The ring carrying the right signal (sleeve is common ground). Single unbalanced 1/4" TRS plug, with the tip carrying the left signal and The line input jack for the stereo channel (channels 3 - 4) accepts a Have something connected to its microphone input each channel isĭesigned to accept only one source or the other. WARNING: Do not connect a channel’s line input if you already Tip/Ring/Sleeve (TRS) plugs wherever possible (unbalanced two-Ĭonductor plugs can also be inserted into these inputs, but you’ll getīetter signal quality and less outside noise and hum if you use balanced Input jacks for monophonic channels (channels 1 - 2) are electronicallyīalanced, so you should use balanced three-conductor cabling and Processors to any of the MIXPAD’s mono or stereo channels. Manual entitled “Setting The Correct Gain Structure.”ģ: Line inputs - Use these 1/4" jacks to connect line-level sources suchĪs synthesizers, drum machines, CD players, tape decks, or effects Properly set this for each channel, see the section on page 23 in this Signal is boosted when the trim is turned to the right of “0” andĪttenuated when turned to the left of “0.” For information on how to Gain (no boost or cut) when set to the “0” (9 o’clock) position. This knob determines the input level of the connected mic or line signal.Ĭontinuously adjustable from -6 dB to -50 dB, the input trim is at unity Input if you already have something connected to its line input eachĬhannel is designed to accept only one source or the other.Ģ: Trim - Provided in monophonic channels only (channels 1 and 2). WARNING: Do not connect a channel’s microphone ), 18 volts of phantom power is delivered to pins 2 and 3 of thatĬhannel’s XLR mic input, enabling you to connect most condenser When the channel’s Phantom Power switch is pressed in (see #2 on Intended to accept signal from low-level, low-impedance mics but canĪlso be used for signal from other sources (such as direct injectionīoxes) if the channel’s Trim control is turned down (see #2 below). To either of the MIXPAD 4’s two monophonic channels. Use these electronically balanced XLR jacks to connect microphones 1: Mic inputs - Provided in monophonic channels only (channels 1 andĢ).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |